TD2410-B

## **Series T** 

- Triac output SSRs; Output rated from 10A to 25A @ 24-240 VAC 

- • AC or DC control 

- Zero-crossing (resistive loads) output 

## **PRODUCT SELECTION** 

|**Control Voltage**|**10A**|**25A**|
|---|---|---|
|3-32 VDC|TD1210|TD1225|
|90-280 VAC|TA1210|TA1225|
|3-32 VDC|TD2410|TD2425|
|90-280 VAC|TA2410|TA2425|



## **AVAILABLE OPTIONS** 

## **OUTPUT SPECIFICATIONS (1)** 

|**Description**|**10A**|**25A**|**10A**|**25A**|
|---|---|---|---|---|
|Operating Voltage (47-63Hz) [Vrms]|24-140|24-140|24-280|24-280|
|Transient Overvoltage [Vpk]|400|400|600|600|
|Maximum Off-State Leakage Current @ Rated Voltage [mArms]|8|8|10|10|
|Minimum Off-State dv/dt @ Maximum Rated Voltage [V/µsec] (2)|200|200|200|200|
|Maximum Load Current (3) [Arms]|10|25|10|25|
|Minimum Load Current [mArms]|40|40|40|40|
|Maximum Surge Current (16.6ms) [Apk]|120|250|120|250|
|Maximum On-State Voltage Drop @ Rated Current [Vpk]|1.6|1.6|1.6|1.6|
|Thermal Resistance Junction to Case (Rjc) [°C/W]|1.48|1.02|1.48|1.02|
|Maximum I2t for Fusing (8.3 msec) [A2sec]|60|260|60|260|
|Minimum Power Factor (with Maximum Load)|0.5|0.5|0.5|0.5|



## **INPUT SPECIFICATIONS (1)** 

|**Description**|**TDxxxx**|**TAxxxx**|
|---|---|---|
|Control Voltage Range|3-32 VDC|90-280 VAC|
|Minimum Turn-On Voltage|3.0VDC|90 Vrms|
|Minimum Turn-Off Voltage|1.0VDC|10Vrms|
|Maximum ReverseVoltage|-32 VDC|-|
|Typical Input Current|3.4 mA @ 5 VDC, 20 mA @ 28 VDC|2 mA @ 120 Vrms, 4 mA @240 Vrms|
|Nominal InputImpedance|1500 Ohm|60 K Ohm|
|Maximum Turn-On Time  [msec]|1/2 Cycle|10|
|Maximum Turn-Off Time  [msec]|1/2 Cycle|40|



## **GENERAL SPECIFICATIONS** 

|**Description**|**Parameters**|
|---|---|
|Dielectric Strength, Input/Output/Base (50/60Hz)|4000 Vrms|
|Minimum Insulation Resistance(@ 500 V DC)|109Ohm|
|Maximum Capacitance, Input/Output|8 pF|
|Ambient Operating Temperature Range|-40 to 80°C|
|Ambient Storage Temperature Range|-40 to 125°C|
|Weight (typical)|3.0 oz (86.5g)|
|Encapsulation|Thermally conductive Epoxy|
|Terminals|Screws and Saddle Clamps Furnished, Unmounted|
|Recommended Terminal Screw Torque Range:|6-32 Screws-10 in lbs. 8-32 Screws-20 in. lbs. (Screws dry without grase)|



## **GENERAL NOTES** 

1) All parameters at 25°C unless otherwise specified. 

2) Off-State dv/dt test method per EIA/NARM standard RS-443, paragraph 13.11.1 

3) Heat sinking required, for derating curves see page 2 

## **MECHANICAL SPECIFICATIONS** 

## **THERMAL DERATE INFORMATION** 

## **AGENCY APPROVALS** 

UL   E116949 CSA   LR81689 VDE   10143 UG 

Rev. 090712 

**==> picture [444 x 279] intentionally omitted <==**

**----- Start of picture text -----**<br>
A DANGER / PELIGRO / DANGER /GEFAHR / PERICOLO / PERIGO<br>HAZARD OF RIESGO DE RISQUE DE GEFAHR EINES RISCHIO DI RISCO DE<br>ELECTRIC DESCARGA DESCHARGE ELEKTRISCHE SCOSSA DESCARGA i<br>SHOCK, ELECTRICA O ELECTRIQUE N SCHLAGES ELETTRICA O ELETTRICA OU H<br>EXPLOSION, EXPLOSION. OU EXPLOSION ODER EINER DELL’ESPLOSI EXPLOSAO H<br>OR ARC FLASH. * Desconectar « Eteindre EXPLOSION. ONE. « Desconectar<br>« Disconnect all todos los toutes les « Stellen Sie « Spenga tutta 0 equipamento H<br>power before suministros de sources Jeglichen 'alimentazion de toda a i<br>installing or energia a este d'énergie de Strom ab, der e che fornisce energia antes<br>working with equipo antes cet appareil dieses Gerat questa de instalar ou<br>this equipment. de trabajar avant de versorgt, bevor apparecchiatu trabalhar com |<br>J . con este equipo. travailler Sie an dem ra prima del este equipamen |<br>= Veifeared dessus de cet Gerat Arbeiten lavorare a questa to<br>connectionsand replace all © lasVerificar conexionestodas appareilia i * durchfihrenVor der apparecchiatui ra e Verificar todas<br>covers before y colocar todas « Vérifier tous Inbetriebnahme « Verificare tutti as conexées e |<br>turning on las tapas antes connections, et alle Anschilisse i collegamenti recolocar todas |<br>power. de energizer remettre tous liberpriifen und e sostituire as tampas<br>Failure el equipo. couverts en alle Gehauseteile tutte le coperture antes de religar |<br>eI meme sous a<br>instruinstructionstionsto followwi will incumplimiento olace:avant da poateeerd sull'alimentaziprima della  one © equipamentoi ||<br>result in death de estas De non-suivi de S nfo araias |<br>or serious injury. instrucciones ces instructions Unterlassung L'omissione di estas instrugdes |<br>puede provoquera la di seguire queste pode levar 4 morte<br>la muerte provocar o mort ou des Anweisungeneter =istruz aeioni ou lesées sérias z<br>lesiones serias. lésions sérieuses kénnen zum provochera la<br>sérieuses. Tode oder zu morte o di<br>schweren lesioni serie<br>Verletzungen<br>fiihren.<br>**----- End of picture text -----**<br>


A WARNING / AVERTISSEMENT / WARNUNG /ADVERTENCIA/ AVVERTENZA/ AVISO RISK OF MATERIAL DAMAGE AND HOT RISQUE DE DOMMAGE MATERIEL ET DE GEFAHR VON MATERIALSCHADEN UND ENCLOSURE SURCHAUFFE DU BOITIER GEHAUSEERHITZUNG + The product's side panels may be hot, allow * Les panneaux latéraux du produit peuvent étre * Die Seitenwande kénnen heif§ sein. Lassen Sie the product to cool before touching. chauds. Laisser le produit refroidir avant de le das Produkt abkiihlen, bevor Sie es berihren. * Follow proper mounting instructions including | toucher. * Beachten Sie die Montageanweisungen, torque values. * Respecter les consignes de montage, et * Fulhren Sie keine Fitissigkeiten oder * Do not allow liquids orforeign objects to enter | "otamment les couples de serrage._ Fremdkérper in das Produkt ein. this product. * Ne pas laisser péneétrer de liquide ni de corps étrangers a l'intérieur du produit. r arloue: Wucty cr euuipeont: dares‘ “a7 result in|. | Ld **e** non-respects lésions corporelles de cette directive graves ou peut des entrainer, KérperverlDie Nichtb **e** achtungtzung oder dieser Materialschaden Anweisung kann yury, ge. dommages matériels. zur Folge haben. RIESGO DE DANOS MATERIALES Y DE : RISCO DE DANO MATERIAL E DE AQUECIMENTO SOBRECALENTAMIENTO DE LA UNIDAD Spal DI DANNI MATERIALI E D'INVOLUCRO * Os paineéis laterais do produto podem estar * Los paneles laterales de! producto pueden *| pannelli laterali dell'apparecchio possono quentes; dé tempo ao produto para arrefecer over calentes. Esperar que el producto se scottare; lasciar quindi raffreddare il prodotto antes de lhe tocar. i enfrie antes de tocarlo. : prima di toccarlo. * Siga devidamente as instrugdes de montagem. aaa “ie wiles - montaje, yen | « Sequire le istruzioni di montaggio corrette. * Nao permita a entrada de liquidos e de objectos * PaISUIA AOS PALES de ApTe arto. * Non far entrare liquidi o oggetti estranei in questo estranhos no produto. No dejar que penetren liquidos 0 cuerpos apparecchio extrafos en el producto. : producirse graves lesiones, dafios materiales. | qannj alle apparecchiature. danos materais. 

Seel A brand of Do not forget to visit us at: www.crydom.com r Copyright © 2012 Crydom Inc. Specifications subject to change without notice. Ez 

## **ANNEX - ENVIROMENTAL INFORMATION**