1705624

https://www.phoenixcontact.com/gb/products/1705624 

## Single contact - PV-PTSPL-W/1R - 1705624 

Please be informed that the data shown in this PDF Document is generated from our Online Catalog. Please find the complete data in the user's documentation. Our General Terms of Use for Downloads are valid 

(http://phoenixcontact.com/download) 

Photovoltaic connector, Single contact, type: Circular conductor connection, single-pos., Connection method: Push-in spring connection 

## Key Commercial Data 

~~GO~~ Packing unit 250 pc Minimum order quantity 250 pc ~~a GO~~ GTIN ~~pC~~ GTIN 4046356789219 ~~a GO~~ Weight per Piece (excluding packing) 1.740 g ~~a G GO~~ Custom tariff number 85389099 ~~GO~~ Country of origin Germany ~~CO~~ Note Made to Order (non-returnable) 

## Technical data 

## Dimensions 

|Length [ l ]|24 mm|
|---|---|
|Hole diameter|1.3 mm|
|General||
|Rated surge voltage (III/3)|4 kV|
|Rated surge voltage (III/2)|4 kV|
|Rated surge voltage (II/2)|4 kV|
|Rated voltage (III/3)|250 V|
|Rated voltage (III/2)|400 V|
|Rated voltage (II/2)|630 V|
|Connection in acc. with standard|EN-VDE|
|Nominal current IN|41 A|
|Nominal cross section|6 mm²|



02/27/2020   Page 1 / 5 

https://www.phoenixcontact.com/gb/products/1705624 

## Single contact - PV-PTSPL-W/1R - 1705624 

## Technical data 

## General 

|Internal cylindrical gage|A3|
|---|---|
|Stripping length|15 mm|
|Connection data||
|Conductor cross section flexible min.|2.5 mm²|
|Conductor cross section flexible max.|6 mm²|
|Conductor cross section flexible, with ferrule without plastic sleeve min.|2.5 mm² min.|
|Conductor cross section flexible, with ferrule without plastic sleeve max.|6 mm² max.|
|Conductor cross section AWG min.|14|
|Conductor cross section AWG max.|10|



## Connection data 

## Standards and Regulations 

|Conductor cross section flexible, with ferrule without plastic sleeve min.<br>Conductor cross section flexible, with ferrule without plastic sleeve max.<br>Conductor cross section AWG min.<br>Conductor cross section AWG max.<br>Standards and Regulations|2.5 mm² min.<br>6 mm² max.<br>14<br>10|
|---|---|
|Connection in acc. with standard|EN-VDE|
|Safety note|• WARNING: Commission properly functioning products only. The<br>products must be regularly inspected for damage. Decommission<br>defective products immediately. Replace damaged products. Repairs<br>are not possible.|
||• WARNING: Only electrically qualified personnel may install and<br>operate the product. They must observe the following safety notes.<br>The qualified personnel must be familiar with the basics of electrical<br>engineering. They must be able to recognize and prevent danger. The<br>relevant symbol on the packaging indicates that only personnel familiar<br>with electrical engineering are allowed to install and operate the product.|
||WARNING: The connectors may not be plugged in or disconnected<br>under load. Ignoring the warning or improper use may damage persons<br>and/or property.|
||• The products are suitable for applications in plant, controller, and<br>electrical device engineering.|
||• Assembled products may not be manipulated or improperly opened.|
||• Only use mating connectors that are specified in the technical data<br>of the standards listed (e.g. the ones listed in the product accessories<br>online at phoenixcontact.com/products).|
||• When using the product in direct connection with third-party<br>manufacturers, the user is responsible.|
||• For operating voltages > 50 V AC, conductive connector housings must<br>be grounded|
||• Ensure that the protective or functional ground has been properly<br>connected.|
||• Observe the corresponding technical data. You will find information:<br>o On the product<br>o On the packing label<br>o In the supplied documentation<br>o Online at phoenixcontact.com/products under the product|
||• The installation notes/Design In documents online on the download<br>page at phoenixcontact.com/products must be observed for this product.|
||• Use a protective cap to protect connectors that are not in use. The<br>suitable accessories are available online in the accessory section of the<br>product at phoenixcontact.com/products|
||• The connector warms up in normal operation. Depending on the<br>ambient conditions, the surface of the connector can continue to warm|



02/27/2020   Page 2 / 5 

https://www.phoenixcontact.com/gb/products/1705624 

## Single contact - PV-PTSPL-W/1R - 1705624 

## Technical data 

## Standards and Regulations 

up. In this case, the user is responsible for posting warnings (e.g. DIN EN ISO 13732-1:2008-12). 

• Operate the connector only when it is fully plugged in and interlocked. • Ensure that when laying the cable, the tensile load on the connectors does not exceed the upper limit specified in the standards. • Observe the minimum bending radius of the cable. Lay the cable without twisting it. 

## Environmental Product Compliance 

China RoHS Environmentally friendly use period: unlimited = EFUP-e No hazardous substances above threshold values 

## Drawings 

## Dimensional drawing 

## Classifications 

## eCl@ss 

**==> picture [298 x 111] intentionally omitted <==**

**----- Start of picture text -----**<br>
|||
|---|---|
|eCl@ss 4.0|27260700|
|eCl@ss 4.1|27260700|
|eCl@ss 5.0|27260700|
|eCl@ss 5.1|27261200|
|eCl@ss 6.0|27261200|
|eCl@ss 7.0|27440204|
|eCl@ss 8.0|27440204|
|eCl@ss 9.0|27440204|

**----- End of picture text -----**<br>


02/27/2020   Page 3 / 5 

https://www.phoenixcontact.com/gb/products/1705624 

## Single contact - PV-PTSPL-W/1R - 1705624 

## Classifications 

ETIM ETIM 3.0 EC001121 ETIM 4.0 EC002638 ETIM 5.0 EC000796 ETIM 6.0 EC000796 ETIM 7.0 EC000796 ~~SSS~~ UNSPSC UNSPSC 6.01 30211810 UNSPSC 7.0901 39121409 UNSPSC 11 39121409 UNSPSC 12.01 39121409 UNSPSC 13.2 39121522 UNSPSC 18.0 39121522 UNSPSC 19.0 39121522 UNSPSC 20.0 39121522 UNSPSC 21.0 39121522 ~~——~~ Approvals Approvals 

Approvals 

EAC 

Ex Approvals 

Approval details 

EAC B.01687  ~~—~~ Accessories Accessories Crimping tool 

02/27/2020   Page 4 / 5 

https://www.phoenixcontact.com/gb/products/1705624 

## Single contact - PV-PTSPL-W/1R - 1705624 

## Accessories 

Crimping pliers - CRIMPFOX 6 - 1212034 

Crimping pliers, for ferrules without insulating collar according to DIN 46228 Part 1 and ferrules with insulating collar according to DIN 46228 Part 4, 0.25 mm² ... 6.0 mm², lateral entry, trapezoidal crimp 

## Screwdriver tools 

Screwdriver - SZF 1-0,6X3,5 - 1204517 

Actuation tool, for ST terminal blocks, also suitable for use as a bladed screwdriver, size: 0.6 x 3.5 x 100 mm, 2- component grip, with non-slip grip 

Phoenix Contact 2020 © - all rights reserved http://www.phoenixcontact.com 

02/27/2020   Page 5 / 5